Reducing TLS Losses in Superconducting Circuits Using Solid Neon
This paper demonstrates that depositing and subsequently evaporating a solid neon film serves as a simple, non-destructive method to significantly reduce two-level system (TLS) losses in superconducting circuits by redistributing and removing surface contaminants.
Original paper licensed under CC BY 4.0 (http://creativecommons.org/licenses/by/4.0/). This is an AI-generated explanation of the paper below. It is not written or endorsed by the author. For technical accuracy, refer to the original paper. Read full disclaimer
In the quiet, frozen world of quantum computing, where machines operate at temperatures colder than deep space, a persistent enemy threatens to ruin the delicate calculations: tiny, invisible defects that steal energy. These defects, known as two-level systems, are like microscopic traps scattered across the surface of superconducting circuits. They absorb the electrical energy meant for computation and release it as heat, causing the machine to lose information. These traps come from many places: the natural rust that forms on metal surfaces, tiny cracks in the crystal structure of the materials, or sticky residues left behind by the manufacturing process. Because these circuits are so sensitive, even the smallest amount of contamination can degrade their performance, limiting how long they can hold a quantum state. Scientists have long sought ways to clean these surfaces without damaging the fragile materials, but traditional cleaning methods often involve harsh chemicals or high heat that can destroy the very components they are meant to save.
A team of researchers at the University of New South Wales has discovered a gentle, non-destructive way to silence these energy thieves using solid neon. By coating their superconducting devices with a thin layer of frozen neon gas and then letting it evaporate, they were able to significantly improve the performance of the circuits. The process works by physically moving the sticky contaminants that cause the energy loss. As the neon freezes and then melts, it acts like a gentle broom, gathering the microscopic debris from the surface of the device and pushing it into small clusters, effectively clearing the path for the electrical signals. This simple treatment resulted in a dramatic increase in the quality of the circuits, with some devices performing up to four times better than before, and the improvement remained even after the neon was completely removed.
The researchers tested this idea using a set of superconducting resonators, which are tiny circuits designed to vibrate at specific frequencies, much like a tuning fork. These devices are fundamental building blocks for quantum processors and sensitive detectors. The team fabricated these circuits using a material called niobium titanium nitride on silicon chips and placed them inside a dilution refrigerator, a machine that cools them down to just twenty thousandths of a degree above absolute zero. They measured how well the circuits held their energy across several cooling cycles. In the first cycle, they established a baseline performance. In the second, they introduced neon gas into the chamber, allowing it to condense into a liquid and then freeze into a solid film on the chips. After measuring the devices with the neon present, they warmed the system back to room temperature to let the neon evaporate completely. In a third cycle, they measured the devices again, now free of the neon, to see if any changes had stuck.
The results were striking. For several of the resonators, the internal quality factor—a measure of how efficiently the circuit stores energy—increased significantly after the neon treatment, even though the neon was gone. In some cases, the performance improved by nearly four times compared to the initial measurement. The researchers carefully analyzed how the devices responded to different temperatures and power levels to understand what was happening. They ruled out the possibility that the improvement came from the neon simply shielding the device from radiation or changing the electrical properties of the circuit in a permanent way. Instead, the data pointed directly to a reduction in the energy loss caused by the two-level systems. The treatment appeared to have removed or rearranged the surface contaminants that were responsible for the losses.
To confirm this mechanism, the team looked at a different material, a flake of hexagonal boron nitride, which was covered in polymer residue from its manufacturing process. They subjected this flake to the same neon treatment and then examined it with an atomic force microscope, a tool that can image surfaces at the scale of individual atoms. The images revealed that the neon had indeed moved the contaminants. Before the treatment, the surface was scattered with tiny particles. After the neon froze and evaporated, those particles had been gathered into larger clumps, leaving vast areas of the surface clean. This visual evidence supported the conclusion that the neon process physically displaces the debris responsible for the energy loss, rather than chemically altering the surface.
The study suggests that this method offers a powerful new tool for cleaning sensitive materials that cannot withstand the harsh conditions of traditional cleaning. Because the process relies on the physical movement of contaminants by a freezing and evaporating gas, it avoids the use of aggressive acids or high temperatures that could damage delicate quantum components. The improvement in performance was not just a temporary effect while the neon was present; the gains persisted after the neon was removed, indicating a lasting change to the surface condition. While the effect varied from one device to another, with some resonators showing dramatic improvements and others showing little change, the overall trend pointed to a successful mitigation of the losses caused by fabrication residues. This approach opens a new path for enhancing the performance of superconducting circuits, potentially allowing quantum computers to operate with greater stability and for longer periods, simply by giving them a gentle, frozen wash.
Drowning in papers in your field?
Get daily digests of the most novel papers matching your research keywords — with technical summaries, in your language.